03-cura/01-configuration/quality/flsun_v400_global_Draft_Quality.inst.cfg

@@ -26,9 +26,6 @@ infill_pattern = ='zigzag' if infill_sparse_density > 80 else 'gyroid'
 infill_overlap = =20 if infill_sparse_density > 80 else 5
 infill_sparse_density = 20
 infill_wall_line_count = 1
-infill_enable_travel_optimization = True
-infill_wipe_dist = =line_width / 2
-wall_0_wipe_dist = =line_width
 zig_zaggify_infill = True
 
 bridge_settings_enabled = True
@@ -48,9 +45,8 @@ top_layers = 5
 bottom_layers = 4
 
 skin_monotonic = True
-skin_overlap = 20
+skin_overlap = 15
 skirt_gap = 10
-skin_edge_support_layers = 4
 
 bridge_skin_speed = 60
 bridge_wall_material_flow = 100
@@ -59,7 +55,7 @@ fill_outline_gaps = False
 
 optimize_wall_printing_order = True
 
-retraction_combing = noskin
+retraction_combing = off
 
 small_feature_speed_factor = 40
 small_hole_max_size = 9
@@ -75,9 +71,6 @@ speed_travel = =speed_print * 2
 speed_layer_0 = 30
 speed_print_layer_0 = =speed_layer_0
 speed_travel_layer_0 = =speed_print_layer_0 * 2
-speed_roofing = =speed_layer_0 * 2
-speed_wall_0_roofing = =speed_roofing
-speed_wall_x_roofing = =speed_roofing
 skirt_brim_speed = =speed_print_layer_0
 speed_slowdown_layers = 3
 
@@ -103,6 +96,4 @@ klipper_retract_speed = =retraction_speed
 klipper_retraction_speed = =retraction_speed
 klipper_pressure_advance_enable = True
 
-material_flow = 94
+material_flow = 88
-
-travel_avoid_supports = True

04-material/PLA/GEETECH/yellow.md

@@ -5,11 +5,11 @@
 | :--------------------------------------------- | :------- |
 | Printing Temperature                           | 200°C    |
 | Build Plate Temperature                        | 60°C     |
-| Flow                                           | 94%      |
+| Flow                                           | 88%      |
-| Retraction Distance                            | 0.3mm    |
+| Retraction Distance                            | 0.85mm   |
-| Retraction Speed                               | 50mm/s   |
+| Retraction Speed                               |          |
-| Retraction Extra Prime Amount                  | 0.05mm   |
+| Retraction Extra Prime Amount                  |          |
-| Linear Advance Factor                          | 0.020    |
+| Linear Advance                                 | 0.044    |
 
 ## Prices